Motor:
Continuous-duty, high starting torque
motor with overload protection. Available in 1/2, 3/4, 1 and
1-1/2 H.P.; single phase capacitor start and three phase
motors. Also available in 2 and 3 H.P. three phase.
Auxiliary Chain
Hoist: Reduced drive chain
with electrically interlocked floor level disconnect for
manual operation. Hoist wheel is easily moved to Right or
Left hand side of unit eliminating the need to order left or
right hand mounting.
Wiring Type: C2, B2, D1
and E2 wiring types are all standard and easily selectable
using the Logic Control Board (L). T and TS wiring can be
activated with the use of the CPSII option board. Reversing
Contactor Units (M) have C2 wiring standard and B2 available
by simply moving a jumper wire. All garage door opener
ratings are pre-wired
to accept a sensing edge, photoelectric control, radio
controls and most types of access control equipment.
Brake:
Solenoid-actuated type standard on 3/4 HP
and higher.
Drive Reduction:
45:1 using heavy-duty gears running in oil
bath. Cast iron housing. Special "All Climate" synthetic
gear oil for greater low temperature performance.
Bearings:
Sealed roller bearings in gear reducer.
External Radio
Control Terminal: External
terminals provide quick, convenient connections for radio
controls.
Pushbutton Station:
3-button station for OPEN/CLOSE/STOP functions is standard
for all operators. Controls with one, two and three buttons
are available.
Standard on
the GarageCreator Logic Control (L):Maintenance
Alert System: This garage door opener rating important feature provides an
accurate method for tracking door use and establishing safe
and effective maintenance programs for he door and the
operator. The Maintenance Alert System features an internal
programmable cycle timer that actually counts each time the
door cycles. This system is easily preset by the installer
for the particular door and application. Once the preset
number is reached, an indicator light on the 3-button
station flashes to signal that it is time for routine door
and operator maintenance.
Maximum Run Timer:
This standard feature on the Logic Control
Board (L) is designed to protect against damage to the door
and operator. Simply set the system to auto learn the door's
standard cycle time. Any time a moving door takes 10 seconds
more than its programmed standard cycle time, the door will
automatically stop. The maximum runtime for the default is
90 seconds.
Delay-on-Reverse Circuit
Programmable
Mid-Stop
Control
Accessories and Options
CPS®
Commercial Protector System: (Recommended) An
inexpensive "non-contact" photo safety sensor designed to
sense an obstruction and signal the door operator to reverse
to open.
Sensing Edge:
(Recommended) Designed to sense an
obstruction and signal door operator to stop or reverse as
desired. Either an electric or pneumatic sensing device can
be added to bottom edge of door garage door opener rating .
Rolling Door
Interlock Switch:
Interlock switch disables the operator control circuit when
a manual door lock is engaged preventing damage to the door
and operator.
Friction Clutch:
Adjustable in-line friction clutch helps
protect against damage to the door and operator should the
door meet an obstruction.
Radio Control:
Universal transmitters and receivers are
available to signal the operator to open and/or close door.
Available Plug-In Option Boards for the Solid State Logic
Control Board (L)
CPS II
Commercial Protector System II: (Recommended)
Features our powerful photo sensors to provide a UL approved
self-monitoring operator for commercial door applications.
4-wire or 2-wire "fail-safe" edges may be used. Board also
contains a Timer-to-Close function.
Timer-to-Close
Option: Part of the CPS II
board. It provides the ability to close the door at a
programmable time from 5 seconds up to 1 hour. Combined with
the CPS II board for the convenience of a timer and the
safety necessary to protect an auto closing door.
Auxiliary Contact
Option Board: Features
both normally-open and normally-closed contact that actuate
when unit is powered down. Can be used to signal security
systems, operate heaters, warning devices or other ancillary
devices garage door opener rating (5V to 240V).
Warning Signal
Option Board: Provides
apartment warning light function for use with red/green
light module (included). Will support audio warning devices.
Will provide warning prior to closing when combined with CPS
II.
